Messages

1

Modification Help / Re: The Corporation's Mod Topic-Industry Combat(Suggest a sniper rifle)

« on: June 30, 2012, 02:45:29 PM »

how about the Barret M98b
like in bf3
just note that its .338 lapua not.50
lots of people make that mistake because its a Barret

or the sniper variant of the SCAR (Mk. 20)

or the DSR-1

2

Modification Help / Re: Blockombat: Major OP+extension updates -Woops my computer is all fwop-

« on: March 10, 2012, 05:17:36 PM »

.338 is strong enough with a winchester, dont cha think? If a lapua is twice as strong, then it would be OP.

This got me thinking, you should make a 22 mm Anzio.

the lapua has the same ballistics (or near same) as a .50 BMG

3

Modification Help / Re: The New Halo Pack ///Bluescreen, Unknown release date :\ ///

« on: March 10, 2012, 05:15:26 PM »

NOOOOOOOOOOO I'M NO LONGER EXCLUSIVE WITH THE PACK!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

/darthvadernoFTW

edit:


Wait! THE STEELWOLF!!! YES!! I STILL HAVE SOME EXCLUSIVENESS!!

not full
I have it
Umad

4

Modification Help / Re: The New Halo Pack ///Bluescreen, Unknown release date :\ ///

« on: February 28, 2012, 07:26:43 PM »

Undead Ninjas Slice Cleanly?

im pretty sure you know what it is but if not
United Nations Space Command
the space military (navy) branch of humans government in halo

5

Modification Help / Re: The New Halo Pack ///Bluescreen, Unknown release date :\ ///

« on: February 25, 2012, 11:14:54 AM »

UNSC would be more appropriate

6

Modification Help / Re: Blockombat: Script progress -Poll- Hot fuzz

« on: February 11, 2012, 11:16:29 PM »

Thank you.

no problem

7

Modification Help / Re: Blockombat: Script progress -Poll- Hot fuzz

« on: February 11, 2012, 07:59:10 PM »

Someone tell me how a G11 works.
Still needs a Type 95.
You can't deny.

The weapon itself has three firing modes: semi-auto, full-auto at 460 rounds per minute, and three-round burst at over 2000 cyclic rounds per minute, which is approximately 36 rounds per second. The loading and feed mechanism is physically very complicated but exceptionally fast and reliable. Rounds are fed into the weapon from a magazine that lies above and parallel with the barrel. The rounds are oriented vertically (at 90 degrees to the bore) and are fed downwards into the rotary chamber so that they can be rotated 90 degrees for firing. The firing cycle process is roughly:

As the roostering handle on the side is rotated clockwise by the weapon operator:
A round is dropped into the revolving chamber vertically (a loading piston assists this process).
The chamber rotates 90° until it is lined up with the barrel. This completes the chambering of the round and roostering of the firing pin.
When the trigger is pulled, a firing pin ignites the primer, which then ignites a powder booster charge that pushes the bullet into the barrel. The solid block of propellant is broken up to increase the ignition surface area and ignites, accelerating the bullet out of the barrel.
As the projectile is accelerating up the barrel, recoil forces drive the barrel, magazine, chamber and operating mechanism rearwards within the weapon, dissipating energy for single shot and fully automatic modes but allowing burst mode to deliver three projectiles downrange before buffering occurs.
Gas tapped off from the barrel rotates the chamber and actuates the loading mechanism then rotating the chamber back to the vertical original position until it is lined up with the feed mechanism and the process repeats.
The weapon uses 4.73x33 mm caseless ammunition, with the propellant shaped into square blocks

8

Modification Help / Re: The New Halo Pack ///Gound Vehicle Scripters Needed!!!///

« on: January 01, 2012, 06:08:40 PM »

bump

9

Modification Help / Re: The New Halo Pack ///Gound Vehicle Scripters Needed!!!///

« on: December 31, 2011, 12:01:55 AM »

lol mid the only reason im still hangin on to BL is for this +blockombat
lost faith gravity cat will finish

10

Modification Help / Re: The New Halo Pack ///Gound Vehicle Scripters Needed!!!///

« on: December 10, 2011, 12:48:28 PM »

add detail to the grip like a RIS

11

Modification Help / Re: Blockombat: Pistol poll! -More waiting- Taking suggestions

« on: December 05, 2011, 02:52:15 PM »

i would have voted for grizzly but I really wanted to see an ACOG Deagle

12

Modification Help / Re: The New Halo Pack ///Gound Vehicle Scripters Needed!!!///

« on: November 29, 2011, 09:21:44 PM »

kev that model is amazing

<3ly love

13

Modification Help / Re: Blockombat: Pistol poll! -More waiting- Taking suggestions

« on: November 27, 2011, 02:24:01 PM »

Zloff the RPS on the Minigun should be between 33.33 and 100 Rounds Per Second
personally recommend 66.66 RPS
or 4000 Rounds Per Minute

14

Modification Help / Re: The New Halo Pack ///Gound Vehicle Scripters Needed!!!///

« on: November 16, 2011, 07:58:11 PM »

and i cant wait to see the PoA's progress. idk when i will be online next though
(and PS, MW3 is awesome! i played with my best friend offline :D )
true, true. lol

Offtopic: ps3?
Ontopic can you post something on the PoA Kevune

15

Modification Help / Re: SAM rocket launcher

« on: October 29, 2011, 10:08:37 PM »

Website i got it off said it was ground. website is wrong then.

and what is surface?
god i hate that
by that i mean not stopping to think for a little