46
Creativity / Re: Blockland Crafts
« on: August 24, 2023, 01:59:32 PM »
One other experiment I tried was taking the white shrink plastic (which is the cheapest kind in most art stores) and trying to glue printed or drawn on cardstock onto it. It didn't give me the results I wanted but I think with enough care, it could yield really good results.
It was also extremely hard getting the sizing right.
I kind of took an outline of the assets I used and made a black outline which I printed out to be quite big, and then I would trace the shape onto the plastic and bake it.
Then I took the same assets and shrunk them by 80% (the plastic shrinks to 20% of its original size). This came out sloppy but surprisingly they were almost the exact size and with enough patience you could probably get them looking great.
If you were drawing onto the cardstock, then you'd just trace the already shrunk plastic and cut it out and then color it. I did this for a set of vampire lips that came out looking like a legit magnet you'd get at 5below or something.

The sides are extremely rough because I plan on sanding the uneven sides down, but haven't yet. The glaze also really muddled the ink, so you'd have to first glue the paper down with some kind of quick drying glue and then put a very thin layer of glaze.
This is what I did for the fox and noob face, and it turned out pretty clean. The MCR ones got soaked because I tried to do something that you'd typically do with modge podge, soaking the paper and then laying it down onto the plastic. I doubt the Spotify code will work so again, I'd glue them down and then use a very thin layer of glaze.
This method is unbelievably pointless if you can afford other plastic, a variety that can be printed on exists, but it's a lot more expensive. Just look for "inkjet" on the shrinky dink's packaging. I used this a lot as a kid, works well but does slightly alter the colors depending on what variety you use.
It was also extremely hard getting the sizing right.
I kind of took an outline of the assets I used and made a black outline which I printed out to be quite big, and then I would trace the shape onto the plastic and bake it.
Then I took the same assets and shrunk them by 80% (the plastic shrinks to 20% of its original size). This came out sloppy but surprisingly they were almost the exact size and with enough patience you could probably get them looking great.
If you were drawing onto the cardstock, then you'd just trace the already shrunk plastic and cut it out and then color it. I did this for a set of vampire lips that came out looking like a legit magnet you'd get at 5below or something.

The sides are extremely rough because I plan on sanding the uneven sides down, but haven't yet. The glaze also really muddled the ink, so you'd have to first glue the paper down with some kind of quick drying glue and then put a very thin layer of glaze.
This is what I did for the fox and noob face, and it turned out pretty clean. The MCR ones got soaked because I tried to do something that you'd typically do with modge podge, soaking the paper and then laying it down onto the plastic. I doubt the Spotify code will work so again, I'd glue them down and then use a very thin layer of glaze.
This method is unbelievably pointless if you can afford other plastic, a variety that can be printed on exists, but it's a lot more expensive. Just look for "inkjet" on the shrinky dink's packaging. I used this a lot as a kid, works well but does slightly alter the colors depending on what variety you use.





