Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Böltster

Pages: 1 [2]
16
Mapping Help / Transparant line on .dif joints
« on: December 17, 2011, 06:47:10 PM »
Is there any way to spawn .dif interiors with the mission editor so they're aligned with the brick grid? Or is there a position i can transform it to so it lines up properly?

I can do it manually of course but it's always off by some amount and takes too much time



[IMaG]http://i42.tinypic.com/25zi2aq.png[/img]
This is at a corner of a test interior. The walls and floor were constructed as separate objects and exported as a single .dif, and for some reason they give me this line?


Sorry for all the problems, still getting the hang of constructor. What do these red lines on certain parts of my interior represent?

Pages: 1 [2]