| Blockland Forums > Clan Discussion |
| {K} Krypt - And the new leader and co-leader are... |
| << < (1214/2030) > >> |
| Xinakam:
--- Quote from: KadeBL_ID12958 on January 27, 2011, 11:42:52 PM ---Hey by "Low poly" in the OP, is there a limit? --- End quote --- It depends on how good the model is. Take a look at the models on the OP. the omniwrench has a very high poly, but is a good model, so it was accepted. |
| KadeBL_ID12958:
Ok then. Still working. Goodnight, i'll finish tomorrow. |
| Xinakam:
--- Quote from: KadeBL_ID12958 on January 27, 2011, 11:48:01 PM ---Ok then. Still working. --- End quote --- I would try to stay under 1000, but it really doesn't matter if you go over. Don't let a limit hinder the design of your model. |
| TheKhoz:
Yea, make it, then start chopping off hidden faces, make cylinders less poly, and, if needed, chop off less important details. |
| Xinakam:
THE MODELERS HAVE SPOKEN! |
| Navigation |
| Message Index |
| Next page |
| Previous page |