Blockland Forums > Modification Help
Milkshape 3D: Making a Tube
flamespike:
--- Quote from: Flubbman on May 21, 2010, 01:46:25 PM ---Probably. I can't use MilkShape, but I want to try it. Unfortunately, Norman Antivirus thinks MilkShape is a virus.
--- End quote ---
Its Norton you loving putz.
Packer:
Tools -> Extended Primitives but its like liking in a separate model so its a bit useless, Majority of things in Milkshape 3D you Must do yourself, any shortcuts are usually bad techniques of modelling.
E.g.
--- Quote from: Deathwish on May 21, 2010, 01:46:03 PM ---Get a vertical cylinder, extrude both of it's top surfaces, scale these new faces down and make sure they're flat with the cylinder's surfaces, then extrude again and scale them on the y by 0.0000001 so they're flush flat in the centre, then delete the centre faces. You'll have a hollow tube.
If you want a tube with a one-sided hollow, just extrude one top surface, scale it down and extrude downwards to the required depth.
--- End quote ---