| Blockland Forums > Modification Help |
| Bounding Box |
| (1/2) > >> |
| (USAF)Airman:
I imported a Sketchup model into Milkshape and then exported as .dts everything goes fine untill I spawn the vehicle in game and then BL crashes, I know it has to do with the bounding box so how do I create that with Milkshape? All help is greatly appreciated thanks. |
| goz3rr:
You will have to make a collision (A group named col-1) that is convex. It can't have any angles greater than 90 degrees. |
| Uristqwerty:
You can't have any angles greater than 180°, not greater than 90°. 90° just doesn't make any sense. |
| otto-san:
--- Quote from: Uristqwerty on October 16, 2010, 05:29:44 PM ---You can't have any angles greater than 180°, not greater than 90°. 90° just doesn't make any sense. --- End quote --- *makes an angle 181°* |
| Uristqwerty:
I should have phrased it "IF there is a limitation, it would be 180°, not 90°", because I was correcting someone else's statement and don't actually know if it is true. |
| Navigation |
| Message Index |
| Next page |