| Blockland Forums > Modification Help |
| My brick isn't working |
| (1/4) > >> |
| Flubbman:
I decided to make a brick for a movie. It uses a custom model. I used Platinum Blockland to generate it, worked fine so far. Then I renamed the .blb file. Then I edited the server.cs and all and put another model than the one I was going to use, since it's WIP. Just to test it. I packaged it right, I know that. It showed up when I started Blockland. But, when I tried to place it, it was the wrong size, and the model wasn't there. Instead it showed up as a normal 2x4 brick, and I couldn't hammer it. The only way to delete it was Ctrl + Z. So, what did I do wrong? |
| Flubbman:
Does anyone ever visit this section? I never get a reply on the same day I post the question... |
| TheKhoz:
Make sure it is a "Special" brick. Make sure your model is in there. Read Spaceguy's reference. |
| Flubbman:
--- Quote from: TheKhoz on January 04, 2011, 03:17:44 PM ---Make sure it is a "Special" brick. Make sure your model is in there. Read Spaceguy's reference. --- End quote --- It has to be "Special"? The pole bricks aren't and they aren't in the "Special" tab. Yes, my model is there. |
| Butler:
--- Quote from: Flubbman on January 04, 2011, 06:30:14 PM ---It has to be "Special"? The pole bricks aren't and they aren't in the "Special" tab. Yes, my model is there. --- End quote --- LOL. No idiot. --- Code: ---x x x SPECIAL --- End code --- |
| Navigation |
| Message Index |
| Next page |