| Blockland Forums > General Discussion |
| print plates make good flat surfaces |
| << < (7/16) > >> |
| The Corporation:
--- Quote from: shinyarceus4 on January 10, 2011, 09:49:24 PM ---Made a test model. This how it works? --- End quote --- Pretty much. Do you have Return To Blockland? |
| shinyarceus4:
Don't even have full version. |
| Dillpickle:
--- Quote from: shinyarceus4 on January 10, 2011, 09:49:24 PM ---Made a test model. -Tinypicsnip- This how it works? --- End quote --- Kinda, if your going for that, Make a line where the glass will be, it should be like Side View Normal shadowbestupid Noedit: 666'th post =P EVILE |
| shinyarceus4:
I can't, it just says "float". |
| Dillpickle:
--- Quote from: shinyarceus4 on January 10, 2011, 10:38:02 PM ---I can't, it just says "float". --- End quote --- I have a colorset which has an invisible color. For you, put down the brick, and then take out the wrench, and on the bottom of the menu. Theres three options [√] Ray Casting [√] Collision [√] Rendering Uncheck Rendering, and it'l go invisible, uncheck Collision, and you can walk through it, uncheck Ray Casting, cars can go through, camera, bullets, and you can't click it. So uncheck Rendering, and then build the plates ontop of that, leveled with the wall. |
| Navigation |
| Message Index |
| Next page |
| Previous page |