| Blockland Forums > General Discussion |
| An experiment with print bricks and water. |
| << < (2/3) > >> |
| Joekirk:
--- Quote from: Pulchritude on January 10, 2011, 12:27:04 AM ---It's been done before, but typically on water that's one third of a brick deep, as when you get under it and look up you can see all the individual bricks. --- End quote --- True, but it can make for a neat affect underwater, sometimes. |
| Shocklink:
This was done before... Also, it carrys too many bricks so I usualy do it for small bodies of water (Like a sink or tub) but for a pond, lake or ocean... May god have mercy on the server and all its people lol |
| The Corporation:
Should I just edit a tile brick addon file to be huge or something? |
| Doomonkey:
Too bad the water FX isn't in it's own paint slot, and undulo isn't the same with different sized bricks. |
| Dillpickle:
--- Quote from: Doomonkey on January 10, 2011, 08:27:49 PM ---Too bad the water FX isn't in it's own paint slot, and undulo isn't the same with different sized bricks. --- End quote --- Name the plate water, duplicate the pond, and set an event for --- Code: ---Onactavate > Namebrick [Water]> ShapeFX [Water] --- End code --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |