Blockland Forums > General Discussion
Hitting '1' every time you open the brick selection menu?
pecon7:
--- Quote from: Eksi on March 27, 2011, 05:30:58 PM ---I haven't actually used the brick inventory for a long time, I find the brick in the menu and right click it to go directly to placing it.
--- End quote ---
This, also I press q twice to clear my menus too :o
Lørd Tøny:
--- Quote from: heedicalking on March 27, 2011, 04:35:54 PM ---Does anyone else do this? I always hit the '1' key and reset my bottom tab to defaults almost every time I open the brick menu. It's some weird habit that bothers me when I don't do it.
--- End quote ---
Here is a simple fix it's what I did.
I set key 1 as brick slot 1.
I set key 2 as brick slot 2 and so on.
You should do the same.
Flubbman:
--- Quote from: Chrono on March 27, 2011, 06:50:27 PM ---I just pile my cart with tons of stuff to the point I get irritated with it and clear it.
--- End quote ---
this
Also, almost everytime I play Blockland, right before I'm going to do something, I take out my hammer and smash the ground. I have no idea why, it's some strange habit of mine.
Wesley Williams:
--- Quote from: Lørd Tøny on March 28, 2011, 02:14:33 AM ---I set key 1 as brick slot 1.
I set key 2 as brick slot 2 and so on.
--- End quote ---
That's what mine/everyone's already are?
I notice myself overloading the cart slot because I war to have more than ten bricks handy. It ends up annoying me and I clear it and put in like three bricks :c
But so that I don't have to go through all the hassle I normally use 2-4 bricks at a time, leaving in blank spaces for the next small group of bricks I use.
Also, I only have 2 favorite groups so I basically never clear my cart hitting a favorite key.
Demian:
Little things that I do while building.
* Mash general area of 123 to open brick inventory.
* Pile my brick cart to the point where it's full of random bricks that I've needed and then clear it.
* Doubletap Q to close paint menu.My default bricks (Fav 1) is 1x1 and the next favorites go in order from shortest to longest: plates (2-3), 1x height (4-5), 5x height (6-7) and 2x height (0). Normally I don't have the 2x height, but I needed it for my ctf_turbine I'm building.