Author Topic: [25x25] drawpixel(); - i am lazy therefore i update this  (Read 19958 times)

Invert colors again


Oh, here's the light switch.

loving backgrounds



form into two circles

code:_multiply=1(3);
code:_adjust-down(2);
code:_adjust-right(2);

Dim NewCircle As New Shape.Circle
Picture.stuff.Add(NewCircle)

form into two circles


From now on, you can actually control the center pixel to do things (Pixel 1:), not just stand there and dupe. The other pixel will do stuff on its own, unless controlled (Pixel 2:).

Also Jacob and Tyler66, no need for confusing Torque code, I accept normal english too.

both pixels increase in size

Also Jacob and Tyler66, no need for confusing Torque code, I accept normal english too.
Its VB aaaaaaaa.

both pixels increase in size


Can't. Your buddy is too close to you.

Its VB aaaaaaaa.
still confusing through. :/

attach the red pixel to the black and gray one

make it into a pixel cannon

attach the red pixel to the black and gray one

make it into a pixel cannon
The black pixel didn't change in size, because otherwise the other one would be stuck.

Also please don't constantly treat this as a suggestion-run paint.NET.
you can actually control the center pixel to do things (Pixel 1:), not just stand there and dupe. The other pixel will do stuff on its own, unless controlled (Pixel 2:).

going to bed, fairly big update in the morning if commands are present

Have pixel + things move apart.



From now on, you can actually control the center pixel to do things (Pixel 1:), not just stand there and dupe. The other pixel will do stuff on its own, unless controlled (Pixel 2:).

Also Jacob and Tyler66, no need for confusing Torque code, I accept normal english too.
Now form a shaft that starts inbetween them and goes up

workplace.entities.pixel=remove:()