Blockland Forums > Modification Help
.22 caliber pistol: Stop overestimating me!
<< < (9/14) > >>
Red Cube:

--- Quote from: The Corporation on July 20, 2011, 02:52:33 PM ---Just sayin' don't try to outline a model in a 2 dimensional sense then extrude it.
It takes a little longer, you are better off just using the cube that you get in a new file and modifying it along the way.

--- End quote ---
I used the cube in a new file :/
And this is the best Blender model I have made yet.
Hydrabisque:

--- Quote from: Red Cube on July 20, 2011, 05:23:11 PM ---I used the cube in a new file :/
And this is the best Blender model I have made yet.

--- End quote ---
It's terrible.  You really need to put more effort into your models besides literally plane modeling.
It takes more than what you do to make a good model, you need to understand that.  Watch more tutorials that help you get better.
Kiddeh:
Stop trying to model.  You're loving terrible at it.
mazeribot:

--- Quote from: Kiddeh on July 21, 2011, 04:45:48 AM ---Stop trying to model.  You're loving terrible at it.

--- End quote ---

Stop being mean. You're loving horrible.
Red Cube:

--- Quote from: Hydrabisque on July 20, 2011, 11:00:01 PM ---It's terrible.  You really need to put more effort into your models besides literally plane modeling.
It takes more than what you do to make a good model, you need to understand that.  Watch more tutorials that help you get better.

--- End quote ---
I can model, it just that I have a small amount of patience. The picture I showed you will be remodeled and revised a lot. I just can't figure out how to do the slide if this is going to have reload animations.

--- Quote from: Kiddeh on July 21, 2011, 04:45:48 AM ---Stop trying to model. You're loving terrible at it.

--- End quote ---
Your whole post was total brutal troll spam. Post something if you actually have something good to say.

--- Quote from: Wynd_Fox on July 21, 2011, 04:13:35 PM ---Can you post a picture now?

--- End quote ---
2nd page.
Navigation
Message Index
Next page
Previous page

Go to full version