| Blockland Forums > Modification Help |
| Collision mesh/parenting problems? (Resolved) |
| (1/1) |
| .::Taboo::.:
Hopefully this wouldn't be crossposting, but just to be sure I'm going to have this here too. --- Quote from: .::Taboo::. on August 17, 2011, 08:15:20 PM ---Would anyone be willing to take a look at the .DTS of my Feisar? I think I might have parented something wrong or made a mistake with the collision box, because attempting to spawn it crashes the game. The hierarchy looks like this at the moment: --- End quote --- .blend: http://www.box.net/shared/jymapvkhtmgzv7h8lknq .dts: http://www.box.net/shared/i7ovdmyt5ipojuudxy5y |
| Blastdown:
Isn't detail0 suppose to be "detail32", or does that matter? |
| .::Taboo::.:
--- Quote from: Blastdown on August 17, 2011, 08:32:35 PM ---Isn't detail0 suppose to be "detail32", or does that matter? --- End quote --- I used the Pickup truck from Phy as a basis, so I don't think it matters. I'm talking it over with yndaaa at the moment, the most likely cause is not in fact the parenting or anything but that I have something misset in the exporter. |
| .::Taboo::.:
--- Quote from: .::Taboo::. on August 17, 2011, 09:15:06 PM ---also, in case it's actually just an effect of my lazy editing it into the motorbike vehicle, here's the attempt at the packaged version. http://www.box.net/shared/7eimj0o8d5uy402knk27 i'm going to try it over the jeep to see if i get any luck. --- End quote --- |
| Navigation |
| Message Index |