Blockland Forums > Modification Help
Bullet Spread
Extrude:
--- Quote from: phflack on September 19, 2011, 02:50:51 AM ---it's not random, well, there's a few different spreads which it then chooses i think, as there's a horizontal 3 spread EXACTLY the same which keeps popping up
--- End quote ---
it's random lol.
phflack:
--- Quote from: Extrude on September 19, 2011, 06:26:57 PM ---it's random lol.
--- End quote ---
then why is there a pattern?
:I
same with the Gshotgun, it just toggles between 2 spreads
Extrude:
getRandom
hur dur
phflack:
--- Code: --- %x = (getRandom() - 0.5) * 10 * 3.1415926 * %spread;
%y = (getRandom() - 0.5) * 10 * 3.1415926 * %spread;
%z = (getRandom() - 0.5) * 10 * 3.1415926 * %spread;
--- End code ---
oh, just so few possibilities that it creates a pattern
i was still right about it repeating itself a lot
--- Quote from: Extrude on September 20, 2011, 05:17:05 PM ---hur dur
--- End quote ---
Extrude:
It has about a 1 in 99999999 x pi chance to repeat itself.