Blockland Forums > Modification Help
Custom prints help-Icons appear, prints don't
soba:
--- Quote from: Pilot1 on November 27, 2011, 12:51:58 AM --- :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie: :cookie:Urmom.
--- End quote ---
You're getting banned, I hope you know that
jes00:
Here is the problem all of the prints need to be 256x256 and all of the icons need to be 64x64, after that it should work.
Also this is not required but I suggest making all of their backgrounds transparent because people tend to not like it if it's not.
Green/Lantern:
--- Quote from: jes00 on November 27, 2011, 06:10:34 AM ---Here is the problem all of the prints need to be 256x256 and all of the icons need to be 64x64, after that it should work.
Also this is not required but I suggest making all of their backgrounds transparent because people tend to not like it if it's not.
--- End quote ---
Mmm. After i posted this thread, I got the icons to work, but the actual prints still wouldn't. I even made them 256x256. They show up as blank on the brick.
Dimitry:
I regret nothing.
Green/Lantern:
--- Quote from: Dimitry on November 27, 2011, 01:09:59 PM ---I regret nothing.
--- End quote ---
Off topic, and not very helpful... Perhaps you should not follow pilot1's path to banland.