| Blockland Forums > Help |
| What should i reduce the print size to? |
| << < (5/6) > >> |
| Robin Ihoodl:
--- Quote from: LeetZero on December 06, 2011, 08:13:50 AM ---Print_1x1f_64x33 Print_2x2f_64x33 Print_1x1_64x33 --- End quote --- Alright, I'll go try this now. |
| Chrono:
--- Quote from: LeetZero on December 06, 2011, 09:07:43 AM ---I don't even know what a 64x33 would fit for. Or if it's 64 in width and 33 in height, or what. --- End quote --- I'm going to assume 64 in width and 33 in height. Which in torque units, would be 32x0.5x19.8 So I would suggest using 4096x2534 (2534.4) or similar ratio. Like 1024x634 (633.6) |
| Robin Ihoodl:
--- Quote from: Chrono on December 06, 2011, 09:51:02 AM ---I'm going to assume 64 in width and 33 in height. Which in torque units, would be 32x0.5x19.8 So I would suggest using 4096x2534 (2534.4) or similar ratio. Like 1024x634 (633.6) --- End quote --- Do you know what i should name the .zip? |
| LeetZero:
--- Quote from: Robin Ihoodl on December 06, 2011, 12:10:31 PM ---Do you know what i should name the .zip? --- End quote --- If you want it a print, regardless of what size you want it, it must be starting with Print_1x1f_... Print_2x2f_... Print_1x1_... And I said it once again, what's that hard to do dammit? Alternatively, if your print is more rectangular; Print_1x2f... Otherwise, the other type of print availible is Print_2x2r... for ramps. |
| Robin Ihoodl:
Ok, I've tried that but nothing is showing up in the prints section of the brick, Do you have IRC or something so i could speak faster to you? |
| Navigation |
| Message Index |
| Next page |
| Previous page |