Blockland Forums > Help
What should i reduce the print size to?
Robin Ihoodl:
--- Quote from: LeetZero on December 06, 2011, 08:13:50 AM ---Print_1x1f_64x33
Print_2x2f_64x33
Print_1x1_64x33
--- End quote ---
Alright, I'll go try this now.
Chrono:
--- Quote from: LeetZero on December 06, 2011, 09:07:43 AM ---I don't even know what a 64x33 would fit for.
Or if it's 64 in width and 33 in height, or what.
--- End quote ---
I'm going to assume 64 in width and 33 in height.
Which in torque units, would be 32x0.5x19.8
So I would suggest using 4096x2534 (2534.4) or similar ratio. Like 1024x634 (633.6)
Robin Ihoodl:
--- Quote from: Chrono on December 06, 2011, 09:51:02 AM ---I'm going to assume 64 in width and 33 in height.
Which in torque units, would be 32x0.5x19.8
So I would suggest using 4096x2534 (2534.4) or similar ratio. Like 1024x634 (633.6)
--- End quote ---
Do you know what i should name the .zip?
LeetZero:
--- Quote from: Robin Ihoodl on December 06, 2011, 12:10:31 PM ---Do you know what i should name the .zip?
--- End quote ---
If you want it a print, regardless of what size you want it, it must be starting with
Print_1x1f_...
Print_2x2f_...
Print_1x1_...
And I said it once again, what's that hard to do dammit?
Alternatively, if your print is more rectangular;
Print_1x2f...
Otherwise, the other type of print availible is
Print_2x2r... for ramps.
Robin Ihoodl:
Ok, I've tried that but nothing is showing up in the prints section of the brick, Do you have IRC or something so i could speak faster to you?