Blockland Forums > Modification Help

Blender help

Pages: (1/1)

Communist:

I want to make dent in some models. However, when I do it, I can only do it to one side at a time. Here:

If you look closely, I only did it to one side.
However, I want it to make it completely symmetrical, instead of doing the other side again and trying to measure out the same distance for the dent as for the other side.
Is there any options for symmetry and/or so the 2 selected faces go away from or to each other when you grab it to move it?

Demian:

I suggest you use Blender 2.6 for modeling. It's far superior to 2.49 if you're not animating. Although both versions do have a mirror modifier if dig around the tabs.

Communist:

--- Quote from: Demian on February 25, 2012, 02:01:28 PM ---I suggest you use Blender 2.6 for modeling. It's far superior to 2.49 if you're not animating. Although both versions do have a mirror modifier if dig around the tabs.

--- End quote ---
I use 2.49 so I can export .DTS files.

Demian:

You can model in 2.6, open the save in 2.49, and export in 2.49.

Pages: (1/1)

Go to full version