Blockland Forums > Modification Help
Brick with Multiple Datablocks?
sonic dude:
is this the real [GSF]Ghost? havent seen you in a while
Robin Ihoodl:
--- Quote from: sonic dude on March 19, 2012, 06:21:15 PM ---is this the real [GSF]Ghost?
--- End quote ---
Oh god i laughed quite a bit.
no mahn sum1 haxcked heim!!!11one!
Khepri:
--- Quote from: YourBuddyBill on March 19, 2012, 03:38:46 PM ---I would laugh so hard if someone mananged to make that.
This isn't the first time it's been asked, I seem to remember trying to figure out if a mario ? block (a print cube) could have a different print on top.
My only guess at all is to have separate bricks, with 0 (or as close to 0 as possible) thickness (for height and width). Frankly, it would be pretty darn cool if someone managed to make that. It would probably be supported from the inside by a cube or something, but idk. Maybe that would work better if the underside had a 2x2 brick attatched as part of it, so there would be a plus-shaped support for them.
All this is just the random speculations of a noob who doesn't know what can't be done, so it's probably way off.
--- End quote ---
Why would you make it a print cube. Just use textures and the correct UV mapping. ???
sonic dude:
--- Quote from: Robin Ihoodl on March 19, 2012, 06:29:00 PM ---Oh god i laughed quite a bit.
no mahn sum1 haxcked heim!!!11one!
--- End quote ---
id rather be taken seriously, but nevermind, i got my answer
YourBuddyBill:
--- Quote from: Khepri on March 19, 2012, 09:28:39 PM ---Why would you make it a print cube. Just use textures and the correct UV mapping. ???
--- End quote ---
Because I can't model or even texture worth stuff. If I could, I'd have done that long ago.