Blockland Forums > Suggestions & Requests
Dirt/Grass cube
Sami2ss:
http://forum.blockland.us/index.php?topic=192915.0
Since the release of polycubes (above), it is now possible to put prints on every side of that brick (more or less), so what I am proposing is the following:
The left is the traditional two bricks used for terrain builds, while the right is what I am suggesting. No lines connecting the brown bricks, but a line connecting the green and brown (the brown should be transparent in the print and take on the color of the brick) and the green should have the blockland stud textures on it. Also, on the bottom of the brick, should be the inlets/reverse studs.
After this, it would be a lot easier to make terrain builds. Just think of minecraft, how the grass blocks have dirt and grass in one.
Peejster:
You can package prints, can't you? Just use this template. http://forum.blockland.us/index.php?topic=192787.0
phflack:
or, just a brick like the 4x cube, just 1 plate shorter
Sami2ss:
--- Quote from: Peejster on May 05, 2012, 03:48:39 PM ---You can package prints, can't you? Just use this template. http://forum.blockland.us/index.php?topic=192787.0
--- End quote ---
i'm not sure how to get the brick texture on the top/bottom without it looking handicapped/off scale and would rather a pro do it than me
Sami2ss:
--- Quote from: phflack on May 05, 2012, 03:51:14 PM ---or, just a brick like the 4x cube, just 1 plate shorter
--- End quote ---
the whole point of this is to save bricks.