Blockland Forums > General Discussion
Plate has 205 million studs
Ipquarx:
--- Quote from: Port on June 05, 2012, 01:11:34 AM ---I found an issue in my calculation. If you filled up the non-glitchy area of Slate with 1x1 bricks, you would have ~6399961600096 * 1037 bricks3.
That's approximately 63999616000960000000000000000 000000000000000000000 bricks3.
--- End quote ---
Where the hell are you getting that from?
There is a total flat surface area of 205520896 bricks, multiplied by height
The height is 19999980 TU multiplied by 6 (1 TU = 2 studs = 6 plates), which is 119999880.
So that's 205520896 multiplied by 119999880, which comes out to be 24,662,482,857,492,480.
Tic-toc26:
there is a height to slate?
Dillpickle:
--- Quote from: Tic-toc26 on June 05, 2012, 07:39:12 PM ---there is a height to slate?
--- End quote ---
There is, but I think we're forgetting that the height of a cube is different then the width.
We have cubes people have made, but default 1x1, the height is bigger then the width.
Treynolds416:
--- Quote from: Ipquarx on June 05, 2012, 06:20:23 PM ---Where the hell are you getting that from?
There is a total flat surface area of 205520896 bricks, multiplied by height
The height is 19999980 TU multiplied by 6 (1 TU = 2 studs = 6 plates), which is 119999880.
So that's 205520896 multiplied by 119999880, which comes out to be 24,662,482,857,492,480.
--- End quote ---
1 TU is 5 plates...
Ipquarx:
--- Quote from: Treynolds416 on June 05, 2012, 10:10:56 PM ---1 TU is 5 plates...
--- End quote ---
I thought 1 TU was 2 studs, which would make 6 plates, but either way it blows
ports estimation way out of proportion.