| Blockland Forums > Suggestions & Requests |
| 1x1 round print brick |
| << < (3/6) > >> |
| Yosher:
--- Quote from: K3k0m@n on July 05, 2012, 01:24:19 PM ---i saw it in a server once. --- End quote --- then why are you requesting this it must already exist then if you saw it |
| Christopher P.:
--- Quote from: jes00 on June 30, 2012, 02:07:01 PM ---Not sure if that's possible. --- End quote --- You set the size of the texture (ui cords i think) less than 1. It's possible. |
| Mr.Noßody:
--- Quote from: Yosher on July 05, 2012, 01:35:21 PM ---then why are you requesting this it must already exist then if you saw it --- End quote --- People don't release everything they make.. Ever hear of private mods? |
| jes00:
--- Quote from: Christopher P. on July 05, 2012, 07:37:31 PM ---You set the size of the texture (ui cords i think) less than 1. It's possible. --- End quote --- UV Coords. EDIT: Also the UV Coords are already below 1. |
| Christopher P.:
--- Quote from: jes00 on July 05, 2012, 09:55:22 PM ---UV Coords. EDIT: Also the UV Coords are already below 1. --- End quote --- Try that, but lower. Try making it loop 2 or 4 times around the brick, that might work. EDIT: because it might not work with just one, unless you make the print shaped like a 1x2 then it could fully cover the brick... |
| Navigation |
| Message Index |
| Next page |
| Previous page |