Blockland Forums > Suggestions & Requests
1x1 round print brick
Yosher:
--- Quote from: K3k0m@n on July 05, 2012, 01:24:19 PM ---i saw it in a server once.
--- End quote ---
then why are you requesting this
it must already exist then if you saw it
Christopher P.:
--- Quote from: jes00 on June 30, 2012, 02:07:01 PM ---Not sure if that's possible.
--- End quote ---
You set the size of the texture (ui cords i think) less than 1. It's possible.
Mr.Noßody:
--- Quote from: Yosher on July 05, 2012, 01:35:21 PM ---then why are you requesting this
it must already exist then if you saw it
--- End quote ---
People don't release everything they make..
Ever hear of private mods?
jes00:
--- Quote from: Christopher P. on July 05, 2012, 07:37:31 PM ---You set the size of the texture (ui cords i think) less than 1. It's possible.
--- End quote ---
UV Coords.
EDIT: Also the UV Coords are already below 1.
Christopher P.:
--- Quote from: jes00 on July 05, 2012, 09:55:22 PM ---UV Coords.
EDIT: Also the UV Coords are already below 1.
--- End quote ---
Try that, but lower. Try making it loop 2 or 4 times around the brick, that might work.
EDIT: because it might not work with just one, unless you make the print shaped like a 1x2 then it could fully cover the brick...