Extrude's Mod Topic

[Extrude]

The old model was one of those glowsticks with the little hanger on the top, but it was really small and bad for BL. Maybe I'll go back to that style but in a larger scale and less 800 polys.

[Ad Bot]

[Ben Grapevine]

So wait that crap was 800 polys what

[Extrude]

This model is like 20 or something. It's just 3 cylinders.

[Ben Grapevine]

This model is like 20 or something. It's just 3 cylinders.

*sigh of relief*

[Rusty]

The glow stick doesn't even look like a glow stick.

[The Corporation]

The glow stick doesn't even look like a glow stick.

This.
Add like grey or something in the middle or on the ends.

[Extrude]

This.
Add like grey or something in the middle or on the ends.

Why would it be grey? It glows green.

[The Corporation]

Why would it be grey? It glows green.

Grey in the middle would represent a grip, so you can throw it/hold on to it.
Grey on the sides/cap represents holding the fluid in.
To be honest, the original model of the glowstick looked better.

[Extrude]

I don't think you've seen a glowstick before, or the original model...

I'm sure nobody who's used the original glowstick would want that horrid model.

[Rusty]

Correction: Yours is a horrible model.

EDIT:

They are glowsticks. Yours is a very low weight dumbbell.

[Extrude]

I don't know what your issue is, but take it to drama.

[Rusty]

You aren't worth a drama topic darling <3

[Extrude]

Also, here's a pic of the old model:


It was much smaller than this one, didn't fit with BL, and was far too high poly. One option would be to flatten one end of the current glowstick, and add a big hanger on to it but it would look pretty bad I think.

[Rusty]

Make one similar to that but with a 6 sided cylinder.

[Extrude]

The reason I dropped it was it looked bad. I'm not going back to that design.