Blockland Forums > Suggestions & Requests
Client-Sided Auto Pilot for Planes
Racerboy:
--- Quote from: phflack on August 07, 2012, 11:58:19 PM ---so
just keeping the speed the same?
--- End quote ---
The same speed that you were going when you activated it.
And the same relative direction.
And stabilize the plane (put it in the up-right position...parallel to the ground)
I thought I explained all of this in the OP.
phflack:
what would change the direction though?
and the person could put it upright to start with
Racerboy:
--- Quote from: phflack on August 08, 2012, 01:21:47 PM ---what would change the direction though?
and the person could put it upright to start with
--- End quote ---
If the plane is just going a little bit down or a little bit up...then it'll just keep escalating. I don't mean the plane's rotation, I mean its direction up or down. It should be flying parallel to the ground in auto-pilot.
giome298:
are you guys dumb?
moveforward(0.5) is pretty much
moveforward(1); and adding walk(1);
I am pretty sure it works
Headcrab Zombie:
--- Quote from: giome298 on August 10, 2012, 03:49:32 PM ---are you guys dumb?
moveforward(0.5) is pretty much
moveforward(1); and adding walk(1);
I am pretty sure it works
--- End quote ---
You're a whole page late