| Blockland Forums > General Discussion |
| Precipitation and zones: Get rid of interior rain |
| << < (5/5) |
| Blocky943:
YUS! |
| Chrono:
--- Quote from: Zaxx on August 17, 2012, 07:11:55 PM ---You don't need the onActivate > Self > setZone > Up [4] [0 0 0] there. Unless the brick isn't a water/zone brick. I'm pretty sure you don't even need the 4 there. Wich makes the splash in the air. I was able to take a normal zone brick with out the events and it did the same thing without splash emmiter in the air. I've done it on water bricks too. --- End quote --- --- Quote from: Eksi on August 16, 2012, 10:37:50 PM ---Since the droplets actually continue for a tiny bit past the splash, a thickness of about 3 or 4 bricks is needed to be completely rid of all traces of rain inside. --- End quote --- |
| Awdax:
--- Quote from: Måster Blåster on August 28, 2012, 06:39:03 AM ---No, that will only let projectiles through. Use rendering, not raycasting, wtf. --- End quote --- Rendering? That will make the window completely invisible. The transparent part and the frame. Might as well just remove the window brick. |
| Navigation |
| Message Index |
| Previous page |