Blockland Forums > General Discussion
Precipitation and zones: Get rid of interior rain
Blocky943:
YUS!
Chrono:
--- Quote from: Zaxx on August 17, 2012, 07:11:55 PM ---You don't need the onActivate > Self > setZone > Up [4] [0 0 0] there. Unless the brick isn't a water/zone brick. I'm pretty sure you don't even need the 4 there. Wich makes the splash in the air. I was able to take a normal zone brick with out the events and it did the same thing without splash emmiter in the air. I've done it on water bricks too.
--- End quote ---
--- Quote from: Eksi on August 16, 2012, 10:37:50 PM ---Since the droplets actually continue for a tiny bit past the splash, a thickness of about 3 or 4 bricks is needed to be completely rid of all traces of rain inside.
--- End quote ---
Awdax:
--- Quote from: Måster Blåster on August 28, 2012, 06:39:03 AM ---No, that will only let projectiles through. Use rendering, not raycasting, wtf.
--- End quote ---
Rendering? That will make the window completely invisible. The transparent part and the frame. Might as well just remove the window brick.