| Blockland Forums > Suggestions & Requests |
| making the poster brick an actual POSTER brick. |
| << < (3/4) > >> |
| The Corporation:
--- Quote from: Mushroom man on September 06, 2012, 10:12:46 PM ---I think I understand... So the textures go all the way to the edge of the brick? Or having the edge textures appear on print bricks too? Which would be nice. --- End quote --- I H I H I H I H I H I H I H I's are the poster brick H's are the 2x2 brick wall it's up against. What I'm talking about- IH IH IH IH IH IH IH The poster brick should be RIGHT UP AGAINST the wall, close enough to not be seen as a separate brick, but not too close to distort/overlay the texture. |
| Yosher:
--- Quote from: Tic-toc26 on September 06, 2012, 08:38:11 PM ----snip- --- End quote --- Please stop posting. |
| Conservative:
I completely get it you look at the poster on the left side of the brick, and the printable face is centered you want an offset so its moved all the way to the edges; and fits in better with walls...one sec |
| Crystalwarrior:
--- Quote from: Conservative on September 07, 2012, 01:55:26 AM ---I completely get it you look at the poster on the left side of the brick, and the printable face is centered you want an offset so its moved all the way to the edges; and fits in better with walls...one sec --- End quote --- PLZ DO IT. It will be really useful :D |
| Conservative:
http://dl.dropbox.com/u/22217440/Brick_Poster_Edged.zip |
| Navigation |
| Message Index |
| Next page |
| Previous page |