| Blockland Forums > Suggestions & Requests |
| Taking Print Requests (again) |
| << < (3/4) > >> |
| SailorMan:
what if we had all the letters on the print plates, but the backround was a 1x1 plate? Ill elaborate later |
| jes00:
--- Quote from: SailorMan on September 17, 2012, 09:10:53 AM ---what if we had all the letters on the print plates, but the backround was a 1x1 plate? Ill elaborate later --- End quote --- I understand. (I think) |
| GEN.Fire Bird:
--- Quote from: GEN.Fire Bird on September 16, 2012, 08:35:27 PM ---lowercase letters. --- End quote --- Why did no one see that? |
| Transformer:
--- Quote from: A_Goat on September 17, 2012, 08:00:01 AM ---SureWill most likely do 1 and 2, I don't know about 3 though.Will do these later. --- End quote --- :D thanks, what I want 3 for is for a tree house I'm making and I would like a leaves print for the cube bricks so I can have leave shapes rather than solid color. If you can attempt 3 for just normal leaves it would be greatly appreciated. I found some textures concepts that could work on this website: http://www.tutorialchip.com/freebies/30-great-small-leaves-textures-and-backgrounds/ ^I want to point out texture #17, 22, & 29 |
| hodototman:
I'd like a cartoon snake print. don't ask |
| Navigation |
| Message Index |
| Next page |
| Previous page |