Blockland Forums > Suggestions & Requests
Taking Print Requests (again)
SailorMan:
what if we had all the letters on the print plates, but the backround was a 1x1 plate? Ill elaborate later
jes00:
--- Quote from: SailorMan on September 17, 2012, 09:10:53 AM ---what if we had all the letters on the print plates, but the backround was a 1x1 plate? Ill elaborate later
--- End quote ---
I understand. (I think)
GEN.Fire Bird:
--- Quote from: GEN.Fire Bird on September 16, 2012, 08:35:27 PM ---lowercase letters.
--- End quote ---
Why did no one see that?
Transformer:
--- Quote from: A_Goat on September 17, 2012, 08:00:01 AM ---SureWill most likely do 1 and 2, I don't know about 3 though.Will do these later.
--- End quote ---
:D thanks, what I want 3 for is for a tree house I'm making and I would like a leaves print for the cube bricks so I can have leave shapes rather than solid color. If you can attempt 3 for just normal leaves it would be greatly appreciated. I found some textures concepts that could work on this website: http://www.tutorialchip.com/freebies/30-great-small-leaves-textures-and-backgrounds/
^I want to point out texture #17, 22, & 29
hodototman:
I'd like a cartoon snake print.
don't ask