Blockland Forums > Suggestions & Requests
Print Brick Doors
tony-0222:
Why have so many doors when you could use a print and have a bunch of different looking designs?
GSF did this in his Add-On topic, but its buggy and doesn't place down correctly.
Someone please fix his door or make one, shouldn't be too hard for some of you, with the obj-blb convertor
Functionality should be just like the default doors, not jvs.
AKA: Change brick state, not animation.
Thank you and please make and release this. You would become famous.
tony-0222:
Bump :panda:
Nymethus:
brick state? you mean the print image?
also, that is not how you use AKA.
Christopher P.:
cant be that hard, all i'd assume could be done is to just change the side texture of the blank door to print
tony-0222:
--- Quote from: Nymethus on December 06, 2012, 01:18:35 PM ---brick state? you mean the print image?
also, that is not how you use AKA.
--- End quote ---
No. I believe there is already a setPrint event.
Change brick state means you click it and it opens and you click it again and it closes without playing animation. It doesen't swing open like JVS, it changes states from the "closed" look to the "open" look. I used AKA right, i believe.