Blockland Forums > Suggestions & Requests
Block/Brick Request: Disk Brick
blockguy123:
--- Quote from: Rembrandt on April 02, 2013, 11:06:41 AM ---Misread as richard brick
--- End quote ---
the hacker:
Couldn't you just make a print?
Daswiruch:
--- Quote from: the hacker on April 05, 2013, 04:23:24 PM ---Couldn't you just make a print?
--- End quote ---
bumping my old topic
I want an actual slightly rounded square with a disk imprint, mang.
Setro:
--- Quote from: Daswiruch on April 06, 2013, 01:33:44 PM ---bumping my old topic
I want an actual slightly rounded square with a disk imprint, mang.
--- End quote ---
Couldn't you use a print and use a colorset with invisibles, and color the brick so it only shows the print?
Can easily be done in blender, by clicking add and then adding a plane and a circle.
I'm really bad at modeling though.
The Resonte!:
--- Quote from: Setro on April 06, 2013, 08:38:06 PM ---Couldn't you use a print and use a colorset with invisibles, and color the brick so it only shows the print?
--- End quote ---
unless you're talking about other prints,
prints also go transparent with colorsets