| Blockland Forums > Suggestions & Requests |
| Block/Brick Request: Disk Brick |
| << < (2/2) |
| blockguy123:
--- Quote from: Rembrandt on April 02, 2013, 11:06:41 AM ---Misread as richard brick --- End quote --- |
| the hacker:
Couldn't you just make a print? |
| Daswiruch:
--- Quote from: the hacker on April 05, 2013, 04:23:24 PM ---Couldn't you just make a print? --- End quote --- bumping my old topic I want an actual slightly rounded square with a disk imprint, mang. |
| Setro:
--- Quote from: Daswiruch on April 06, 2013, 01:33:44 PM ---bumping my old topic I want an actual slightly rounded square with a disk imprint, mang. --- End quote --- Couldn't you use a print and use a colorset with invisibles, and color the brick so it only shows the print? Can easily be done in blender, by clicking add and then adding a plane and a circle. I'm really bad at modeling though. |
| The Resonte!:
--- Quote from: Setro on April 06, 2013, 08:38:06 PM ---Couldn't you use a print and use a colorset with invisibles, and color the brick so it only shows the print? --- End quote --- unless you're talking about other prints, prints also go transparent with colorsets |
| Navigation |
| Message Index |
| Previous page |