Blockland Forums > Suggestions & Requests
Save wrench events ON by defualt!
Crazy ManMan:
Okay so I will admit I am a bit POed right now because for the THIRD time the save wrench events was off from a previous save and I forgot to turn it back on and ALL of my events and teleporters on a LARGE build were COMPLETELY cleared and I had to re-do ALL OF IT! Pleas make it so save wrench events on by default. We can fix it that way we can not undo saving without events!
Edit 1: I should mention I probably will not be checking this thread often, I am a bit busy usually.
Edit 2: At the very least there should be a window that comes up that says "are you sure you want to save with events turned off?"
TeeOS:
But, saving always covers events though...
Honorabl3:
--- Quote from: TeeOS on May 12, 2013, 06:21:14 PM ---But, saving always covers events though...
--- End quote ---
When saving there is a boolean option to save wrench events. If I remember correctly, the option is on by default.
Zeblote:
--- Quote from: Crazy ManMan on May 12, 2013, 06:16:39 PM ---the save wrench events was off from a previous save
--- End quote ---
Just don't turn it off (why would you ever do it) and then it is alwayso n by default.
Crazy ManMan:
--- Quote from: Honorabl3 on May 12, 2013, 07:06:56 PM ---When saving there is a boolean option to save wrench events. If I remember correctly, the option is on by default.
--- End quote ---
Yes but when you turn it off it stays off until you turn it back on (even 20 saves later)
--- Quote from: Zeblote on May 13, 2013, 01:36:59 AM ---Just don't turn it off (why would you ever do it) and then it is alwayso n by default.
--- End quote ---
Sometimes there is an awesome build you want to keep that has crappy/laggy events all over or in places you can not find, but you still want to keep the build.