Blockland Forums > General Discussion
get your forum avatar to a print
Hawt:
so today I made a betelguese print, and then I had this idea that I could post a topic for the community to get their avatar a print.
Betelguese (Garfield)
-low quality
-i did 1x1, it works on both of them except ground prints
-made a garfield race
Download - 456 KB
Yin Yang
-not tested
-may not work
Download - 542 KB
Flatflyer
-not tested
Download - 299 KB
Redconer
-not tested
-looks creepy
Download - ??? KB
Yin Yang:
You should make mine, on a big brick (the 1x5x5 or whatever) print, ramp plate, and a 1x1f so i can make a floor of me
LeetZero:
Maybe we should actually make one of those collab images things and put them on a poster print instead.
Hawt:
--- Quote from: Yin Yang on February 02, 2014, 07:41:26 PM ---You should make mine, on a big brick (the 1x5x5 or whatever) print, ramp plate, and a 1x1f so i can make a floor of me
--- End quote ---
i only know the 1x1 and the uh
that big one that is default
btw creative use:
Operator¹:
instead of making them prints, you should just set your avatar as a stud texture.