| Blockland Forums > Suggestions & Requests |
| Updated Vertical Prints |
| (1/2) > >> |
| Jontron:
Could someone make a mod that allows vertical prints to be able to overlap each other? |
| LeetZero:
--- Quote from: Jontron on February 11, 2014, 02:34:03 PM ---Could someone make a mod that allows vertical prints to be able to overlap each other? --- End quote --- That is not possible. It doesn't work lthat way. It's the same case as for brick overlap. There was a old private mod which was failbinned like once and then forgotten which did allow brick overlaps. But not sure if it even works anymore. And even so you wouldn't be able to find it. |
| jes00:
--- Quote from: LeetZero on February 11, 2014, 04:13:45 PM ---That is not possible. It doesn't work lthat way. It's the same case as for brick overlap. There was a old private mod which was failbinned like once and then forgotten which did allow brick overlaps. But not sure if it even works anymore. And even so you wouldn't be able to find it. --- End quote --- Easy to make a new one. But overlapped bricks are kinda buggy. |
| Crispy_:
Try a combination of water and brick zones. |
| Jontron:
--- Quote from: Crispy_ on February 11, 2014, 05:12:16 PM ---Try a combination of water and brick zones. --- End quote --- I kinda mean like, put 2 1x2 vertical plates in the same area, just opposite sides. |
| Navigation |
| Message Index |
| Next page |