| Blockland Forums > Suggestions & Requests |
| Updated Vertical Prints |
| << < (2/2) |
| Advanced Bot:
--- Quote from: Jontron on February 11, 2014, 10:56:11 PM ---I kinda mean like, put 2 1x2 vertical plates in the same area, just opposite sides. --- End quote --- Huh? |
| Hawt:
--- Quote from: Advanced Bot on February 11, 2014, 11:07:20 PM ---Huh? --- End quote --- since 1 brick = one stud, he wants you to build in the stud. |
| Advanced Bot:
That would be terrible to do |
| LeetZero:
--- Quote from: Advanced Bot on February 13, 2014, 10:23:14 AM ---That would be terrible to do --- End quote --- Not with the vertical print pack, not necessarily. But depending on how it's used, it may be. For instance if you use the 1x1f vertical print rotated twice on the same brick, they will still have a gap inbetween and it wouldn't actually have any overlaps. But in general if used outside of that, used wrongly or simply used with other bricks, yes, it's a terrible thing to do. |
| Crispy_:
--- Quote from: Crispy_ on February 11, 2014, 05:12:16 PM ---Try a combination of water and brick zones. --- End quote --- You can place a normal zone/layer brick inside a water layer/brick. This is noticeable with placing giant cubes in mod-ter bricks. Just make a version of vertical prints that uses the water layer and you would be able to place two in the same spot. |
| Navigation |
| Message Index |
| Previous page |