Blockland Forums > General Discussion
Is there a way to generate a list of addons/bricks used in a save?
tber123:
--- Quote from: otto-san on February 22, 2014, 09:42:25 AM ---the problem is that you don't have a list of all brick mods and the uinames associated with them
and even if you did, there will definitely be cases where multiple packs use the same uiname for one kind of brick. you wouldn't think this is an issue because it's the same brick in both packs, but then you have to consider which pack was actually active for the build
this is why RTB was able to provide the service, because they hosted a large amount of blockland's mods, and they could generate such a list
--- End quote ---
What if I had all the brickpacks from RTB installed, but not used? (I used the RTB megadump.)
Threule:
--- Quote from: tber123 on February 22, 2014, 11:09:12 AM ---What if I had all the brickpacks from RTB? (I used the RTB megadump.)
--- End quote ---
Unless you used all the brickpacks, which there are some repeated, the OP's idea should only list the ones that are used. If you have poles downloaded but you dont need to use em, you wont see them listed.
otto-san:
--- Quote from: tber123 on February 22, 2014, 11:09:12 AM ---What if I had all the brickpacks from RTB? (I used the RTB megadump.)
--- End quote ---
you would still need to generate the list
0xBRIANSMITH:
I can probably try some things later, Ill report back.
tber123:
--- Quote from: otto-san on February 22, 2014, 12:53:37 PM ---you would still need to generate the list
--- End quote ---
I mean that if I had all the bricks installed but not used, would there no problems generating a list?