| Blockland Forums > Suggestions & Requests |
| Requesting Door Textures |
| (1/2) > >> |
| LeetZero:
I am making a new door set, completely disbanding my old one, and each door will support prints. Also they have actual side textures and all. But I am pretty bad at making these prints, thus, I am requesting from you to make some prints. The size of the print itself must be in a ratio of 6 by 11. But after the print is complete, must be resized to 512x512 out of the ratio. Paint.NET: Just post them in here directly, no need to PM me or anything. Primarily I am looking for a Wood texture as the one I made is pretty bad, a plank texture, a battered/damaged texture and some "reinforced" texture. If you have any other ideas feel free to add them in. You will of course be credited for the prints on the release. |
| Threule:
So ratio of 6:11? You should try to make the prints be 2x1 blocks (512x256) |
| LeetZero:
--- Quote from: Threule on March 22, 2014, 09:35:20 AM ---So ratio of 6:11? You should try to make the prints be 2x1 blocks (512x256) --- End quote --- This uses the same size ratio as the default door, that's all. Also the print itself must be square as far as I know. |
| Threule:
--- Quote from: LeetZero on March 22, 2014, 09:37:22 AM ---This uses the same size ratio as the default door, that's all. Also the print itself must be square as far as I know. --- End quote --- There are some decals for 1x2 flat bricks that are 512x256 |
| LeetZero:
--- Quote from: Threule on March 22, 2014, 10:07:55 AM ---There are some decals for 1x2 flat bricks that are 512x256 --- End quote --- Still wouldn't be able to work. At the very least a 6:11 on a 512x256 can work (I think) could also work I suppose, but it still needs to be either cropped or stretched. |
| Navigation |
| Message Index |
| Next page |