Author Topic: [Brick] Plate high ramps v1.1 - now with halfbrick high ramps! Also prints (Read 11647 times)

I meant 45 degree slopes, cause i really don't wanna have a slope made of these ramps with studs on them, but suddenly the ugly default ramp with a smooth side that dosen't fit in.

now that i think about it, this is a pack of plate high ramps, forget my suggestion. i feel like 45 degree roads are just too slanted to look normal

TheTurtorn · November 20, 2016, 06:14:19 PM

Updated the pack with halfbrick high ramps, there's also a separate print pack.

Quote from: NotBomberguy on November 19, 2016, 04:05:15 PM

also where were you all this time turt
its been like
a year

Just wanted to take a break for awhile, so I left quietly. Did forget all during that year though :\

Quote from: Superfun909 on November 20, 2016, 11:09:35 AM

forget my suggestion

Already happened

MoltenKitten · November 20, 2016, 06:29:30 PM

So are you back to making addons or was this just a spur of the moment?

Filipe · November 21, 2016, 11:27:45 AM

This is incredibly useful, it sure will be a handful for roads!

DaBlocko · November 21, 2016, 12:05:02 PM

Quote from: TheTurtorn on November 18, 2016, 12:35:52 PM

Print versions should be easy to do, though I don't think side prints would work as it would require different prints for each of the 30 bricks or they'll stretch, I'll just do a tiling print texture. However, I can make a separate pack with side textures applied instead of the studs like tile plates, if you need them.

Oh right good point. Thanks for adding printable ones!!

Superfun909 · November 21, 2016, 03:57:41 PM

Quote from: TheTurtorn on November 20, 2016, 06:14:19 PM

Already happened

fine then tho, they look cool anyway!

SuperSuit12 · December 04, 2016, 04:11:58 PM

these have culling errors, when my viewpoint is below them the tops vanish
at least on the print ones