| Blockland Forums > Suggestions & Requests |
| Wire Prints. Should I Release? |
| (1/3) > >> |
| Makanix:
Scroll down and look at the post with the last picture on it so I don't have to repost up here. |
| Meekl:
EPIC WANT |
| Rocketttdog:
Yes |
| Makanix:
OK... i made the corner 2x2f. The corner is a fuse box. i might change so it is only the fuse box on the end because you can only turn left with the one i made... I also might make a 1x1 so you can turn on the wall too. im still working on it... Pics: Just a few more Yes's and i might release them... |
| Dr.Block:
I like these, release them :D The little green wire doesn't line completely up with it's self when the print repeats on the next brick, maybe tweak that a bit. Otherwise, very good :D |
| Navigation |
| Message Index |
| Next page |