| Blockland Forums > Suggestions & Requests |
| Wire Prints. Should I Release? |
| << < (3/3) |
| Makanix:
--- Quote from: Gen. Nick on June 26, 2009, 01:35:12 AM ---Looks cool, but needs more curly wires. Not too curly, but it looks like pipes if half of its straight. --- End quote --- If people like these I might post pipes too. |
| rkynick:
I don't like the gradient look to some of the prints, namely the panels. Use solid colours. |
| Mr.Noßody:
Most definitively needed. |
| Makanix:
I released them! go to the print/decal section... |
| Navigation |
| Message Index |
| Previous page |