| Archive > Mapping Help |
| Backfaces in Torque Cons |
| << < (3/3) |
| Marcem:
--- Quote from: heedicalking on December 01, 2009, 07:03:48 AM ---They are not appearing AND you can walk through them. Could this be from a use of CSG subtract? --- End quote --- Most likely, if any faces look like an X in 2d view, redo it. The X means it's broken, this often happens with CSG subtract, clip, slice, and knife. |
| LoserHero:
CSG Subtract is a fine tool, you must be doing something wrong if it's causing problems for you. |
| Deathwishez:
I've never had this problem. My first gues would be to restart the program. If the problem persists, re-install it. After that, either get a new program, and check your PC. |
| Navigation |
| Message Index |
| Previous page |