Archive > Mapping Help
Backfaces in Torque Cons
Marcem:
--- Quote from: heedicalking on December 01, 2009, 07:03:48 AM ---They are not appearing AND you can walk through them. Could this be from a use of CSG subtract?
--- End quote ---
Most likely, if any faces look like an X in 2d view, redo it. The X means it's broken, this often happens with CSG subtract, clip, slice, and knife.
LoserHero:
CSG Subtract is a fine tool, you must be doing something wrong if it's causing problems for you.
Deathwishez:
I've never had this problem. My first gues would be to restart the program. If the problem persists, re-install it. After that, either get a new program, and check your PC.