Blockland Forums > Suggestions & Requests
Vertical Plate Bricks
Tokthree:
--- Quote from: chilmans on January 20, 2010, 09:34:47 AM ---just make a ****ing print for the 4x4 (/1x1) print brick
--- End quote ---
I fail to understand how a print can function as an entire new brick, nor your need to swear
Tezuni:
We Need:
-Cubes covered in studs (Top, Sides, and Bottom)
-Ability to rotate bricks upsidown and sideways (Ex: Tree top is facing down)
With this you could plant bricks sideways or even upside down on cubes covered in studs.
Also it'd be fun to have the ability to rotate players upside down.
flamespike:
--- Quote from: Tezuni on January 20, 2010, 03:01:17 PM ---We Need:
-Cubes covered in studs (Top, Sides, and Bottom)
-Ability to rotate bricks upsidown and sideways (Ex: Tree top is facing down)
With this you could plant bricks sideways or even upside down on cubes covered in studs.
Also it'd be fun to have the ability to rotate players upside down.
--- End quote ---
YUS!
Niven:
--- Quote from: Tezuni on January 20, 2010, 03:01:17 PM ---
-Ability to rotate bricks upsidown and sideways (Ex: Tree top is facing down)
With this you could plant bricks sideways or even upside down on cubes covered in studs.
--- End quote ---
Can't.
Badspot would have to redo the Torque engine. Or something like that. But it's impossible
ChexGuy331:
--- Quote from: Tokthree on January 19, 2010, 05:03:35 AM ---It just seems strange that the height of bricks are measured in 1/3rd's but not the width.
--- End quote ---
Get a bucket of LEGO bricks and you'll understand.