My print bricks are glitched.

[Warbler]

 All print bricks show the design on the top of the brick. I try to change prints, but it shows blank. I have all my print add-ons enabled. Any suggestions on what to do?

[Ad Bot]

[Doomonkey]

Perhaps you have too many add-ons. Also, there is some add-on that breaks prints, try using only default add-ons, and then adding more one at a time until you find the problem.

[Warbler]

Ok I'll try that.

[Warbler]

I I did what you said to do but they're still broken.

[SigSawer]

I have the same problem,

[Shadoku]

Did you only enable the default add-ons yet to see if they were still broken?

[SigSawer]

using only default add-ons, and only default maps, the prints are still broken.

[SigSawer]

Update: Problem fixed. I think i was just over stocked on add-ons, i deleted a few and it works perfectly now. Or it could of just been one corrupted file, meh, whatever.

[Shadoku]

Glad to here that.