First 3D Gun Attempt

[keonesan]

I couldn't tell if this went into creativity or Off-Topic so... Yeah whatever.

Anyways I got back into Blender and I decided to take a crack at modeling a gun. Like usual it came out stuffty but NOT AS bad as I usually do.

This is my first crack at a gun (or at least first COMPLETED attempt) and I was hoping to get some tips on how to make it look better.

P.S. Any methods to modeling hands? :s

[Ad Bot]

[Domidore66]

There's a 3D modeling topic in creativity...

[Azzurolix]

So you hold this gun with your ring finger and pinky?

[keonesan]

There's a 3D modeling topic in creativity...

Well please do excuse the fact that I don't keep an updated log on every thread created.

[steve5451]

Stretch it out vertically, it seems kind of compressed. :o

[zackin5]

Well please do excuse the fact that I don't keep an updated log on every thread created.

This thread should go in creativity, And if you were going to put it there you would have seen the thread.

[SeventhSandwich]

Not bad for a first model.

I should go find my old hat models

[keonesan]

Not bad for a first model.

I should go find my old hat models

Isn't my FIRST model but might as well be.

I haven't modeled in ages and even then my previous stuff looked like complete, undefinable stuff.

This thread should go in creativity, And if you were going to put it there you would have seen the thread.

I see. I don't go to creativity often but to think I would have seen that thread.
I'll let this run it's course and if it's not dead tomorrow I'll lock it.

[Raeyok]

Not too shabby for a first model, my friend. And there's always room for improvement.