Brick Arrows Mod

Author Topic: Brick Arrows Mod  (Read 6688 times)

This evening... I am going fix the pole bit and I will add arrow rear end above the picture like that. It should be release soon after add speedkart's arrows.

Why not make the arrow post printable on both sides?

Why not make the arrow post printable on both sides?
all of my models?!?!  or which one the model you want use for the prints?

all of my models?!?!  or which one the model you want use for the prints?
Just this one. It is a sign after all.

OK, I am going sent you a file obj, I am sure you can handle it?
I am going work on the print on arrow post.
« Last Edit: December 17, 2014, 03:08:55 PM by Furling² »


Added new arrow: Bottom and Top.
Issues [need fix]:
prints not show on the brick.
Position brick correct.

EDIT: I am going make pole arrow look like blocky, not round the pole.
« Last Edit: December 17, 2014, 06:51:29 PM by Furling² »

If you send me the BLBs, I can probably figure out the print issue.

Tell me what you think of these with the prints aslo new mock up the blocky arrows.

The seem a bit stretched horizontally.


Release at add-ons thread, check it out :)

I meant the decals look stretched.

I meant the decals look stretched.
Nope, It was my monitor has bad stretched. That why I can see it better in game BL Solo as look fine. You can download the add-ons and try it out.

This project little delay time, I think on Tuesday or Wednesday. I will be back work on my project. Don't worry about arrow of grey stuff!