Some blocks only show grate print... again

[TableSalt]

Basically all the non-default print bricks only show the grate print... again.
I do have the modter prints.

[Ad Bot]

[phflack]

did you try changing the print? like, does it always show that even if you change it to something else?
does it work if you disable all of your other add-ons?

[TableSalt]

did you try changing the print? like, does it always show that even if you change it to something else?
does it work if you disable all of your other add-ons?

I can't change the print, it always shows the grate.
It does work when no other add-ons are enabled.

[Zeblote]

Try changing the print (it wont work) then close blockland and post console.log.

[TableSalt]

Try changing the print (it wont work) then close blockland and post console.log.

Okay.

[Zeblote]

Try disabling Event_Print_Events and Event_Print and say if that fixes it.

[K3k0m@n]

Try disabling Event_Print_Events and Event_Print and say if that fixes it.

Event_Print is probably not it as it's worked perfectly for me
Print_Events I've never heard of

[Zeblote]

Print_Events I've never heard of

It's an old failed add-on that has been re-named to work again

[TableSalt]

Try disabling Event_Print_Events and Event_Print and say if that fixes it.

I disabled both, it didn't help.

[TableSalt]

bump

[LeetZero]

Could you post the savefile which contains such a brick?

[Goth77]

Get rid of Tool_Fill_Printer and see if that helps.

[TableSalt]

Get rid of Tool_Fill_Printer and see if that helps.

I had fill printer before this, it was fine.
But I'll try anyways.

[TableSalt]

I completely forgot about this.
Well, the problem mysteriously went away, I didn't have to get rid of the fill printer.
Lockin' now.