Requesting Door Textures

[LeetZero]

I am making a new door set, completely disbanding my old one, and each door will support prints. Also they have actual side textures and all.

But I am pretty bad at making these prints, thus, I am requesting from you to make some prints.
The size of the print itself must be in a ratio of 6 by 11. But after the print is complete, must be resized to 512x512 out of the ratio.
Paint.NET:

Just post them in here directly, no need to PM me or anything.

Primarily I am looking for a Wood texture as the one I made is pretty bad, a plank texture, a battered/damaged texture and some "reinforced" texture. If you have any other ideas feel free to add them in. You will of course be credited for the prints on the release.

[Ad Bot]

[Threule]

So ratio of 6:11?

You should try to make the prints be 2x1 blocks (512x256)

[LeetZero]

So ratio of 6:11?

You should try to make the prints be 2x1 blocks (512x256)

This uses the same size ratio as the default door, that's all.
Also the  print itself must be square as far as I know.

[Threule]

This uses the same size ratio as the default door, that's all.
Also the  print itself must be square as far as I know.

There are some decals for 1x2 flat bricks that are 512x256

[LeetZero]

There are some decals for 1x2 flat bricks that are 512x256

Still wouldn't be able to work. At the very least a 6:11 on a 512x256 can work (I think) could also work I suppose, but it still needs to be either cropped or stretched.

[Renderman]

this... actually sounds like a great idea when I think about it